4 steps to repair the flap barrier failure, easy to fix the flap barrier failure
4 steps to repair the flap barrier failure, easy to fix the flap barrier failure
Abstract: flap barriers often encounter some minor problems during use, such as: real-time alarm failure, safety protection device failure, intelligent control and management failure, and LED count display failure. When this kind of failure occurs, don't be in a hurry. The Chuangxintong manufacturer will give you a brief analysis today and the specific solutions for the above-mentioned situations. Allows you to easily fix minor faults in the wing brake. flap barrier
flap barriers often encounter some minor problems during use, such as real-time alarm failures, safety protection device failures, intelligent control and management failures, and LED count display failures. Don't be in a hurry when this kind of failure occurs. Chuangxintong will give you a brief analysis today and the specific solutions for the above situation. Allows you to easily fix minor faults in the wing brake.
The flap barrier is a kind of intelligence that is equipped with various read-write equipment, real-time alarm system, safety protection device, LED count display and direction indication interface to coordinate and complete the whole process from swiping card to recognition to opening to closing. Control and management of the channel system. The daily troubleshooting of the flap barrier can be completed through the following four steps.
1. Detect whether the limit photoelectric switch is irradiated by strong light (multi-fingers are installed and debugged outdoors):
Specific detection method: If you need to open the case or the cover of the movement of the flap barrier during inspection, it is best to cover the limit photoelectric switch with a dark color opaque object and then carry out debugging to avoid the strong light from illuminating the limit photoelectric switch. Influence!!
2. Check whether the connection between the limit photoelectric switch and the main board is reliable;
3. When the detection limit photoelectric switch and connection are normal, the main board may be damaged.
4. The method of detecting the limit photoelectric switch of the flap barrier:
(1) Check the zero position, the left opening in place, and the flap barrier failure. Check whether the limit photoelectric switch of the right opening in place is powered! Check if the 4PIN thread is loose or in poor contact;
(2) Enter the debugging menu P00, check the fault of the wing brake, and turn the brake shaft to drive the light-blocking piece to sequentially separate the open-left, zero and right-open limit photoelectric switches of the limit photocoupler, and cut off
When optocoupler, the indicator light should be on and the output voltage is +12V, otherwise the limit photoelectric switch will be damaged.
flap barrier as an electronic product may cause some failures during use, but from the perspective of the flap barrier, the main reasons generally focus on the configuration and system of the flap barrier. The overall maintenance principle of the flap barrier is mainly from the following 4 points 1: real-time alarm system 2: safety protection device 3: intelligent control and management system 4: LED count display, etc. Generally speaking, the flap barrier will be eliminated after the above 4 failures. If the fault still exists at this time, we should contact the manufacturer for technical guidance in time.
