Steps for debugging the limit photoelectric switch of tripod turnstile
Steps for debugging the limit photoelectric switch of tripod turnstiles
Abstract: From the perspective of the commissioning and installation of the tripod turnstile, how to quickly debug the limit photoelectric switch of the tripod turnstile requires a combination of related installation technology and experience......
From the perspective of the debugging and installation of the tripod turnstile, how to quickly debug the limit photoelectric switch of the tripod turnstile should be combined with related installation technology and experience, understood from the perspective of the tripod turnstile manufacturer, and mastered the knowledge of the tripod turnstile limit photoelectric switch. Realize the improvement of the installation and adjustment efficiency of the tripod turnstile, and the ability to detect leaks in the tripod turnstile system. How to adjust the limit photoelectric switch of the tripod turnstile reasonably and quickly?
Professional channel gate manufacturer-Chuangxintong Technology, teaches you the adjustment of the limit photoelectric switch of the tripod turnstile with the attitude of the tripod turnstile manufacturer. There are three main steps, namely: tripod turnstile system locking, fire-fighting unlocking and passage unlocking.
1. Three-roll gate system locking: when in the locked position, the green indicator light of the unlocked photoelectric switch (double light lotus small board) is on, and the GUI_R indicator light on the corresponding main control board is on, indicating that it is in the locked position;
2. Three-roll gate fire-fighting unlocking: When the equipment is powered off, the backup power control board will drive the motor to the unlocked position and locked position. At this time, the channel should be in a fire emergency state. Add and unlock the photoelectric switch (double light lotus root plate) limit photoelectric red indicator light is on. The gate can pass in both directions;
3. tripod turnstile pass unlocking: When the card is swiped normally, such as when the pass card is swiped, the corresponding pass electromagnet is unlocked, and the pass is allowed, but it cannot be reversed. When the pedestrian passes through the rear gate and runs to the zero position, the red indicator light of the outgoing switch board is on, and the zero signal is output, and the ZERO indicator light on the corresponding main board is on, and the device is in the locked state again. In the same way, when the direction pass card is swiped out, the corresponding out direction pass electromagnet is unlocked, the out direction pass is allowed, but the reverse direction is not allowed. When the pedestrian passes through the rear gate and runs to the zero position, the red indicator light of the outgoing switch board is on, and the zero signal is output, and the ZERO indicator light on the corresponding main board is on, and the device is in the locked state again.
The above is about the "Triple Roller Gate Limit Photoelectric Switch Debugging Steps" compiled by Chuangxintong Technology for the majority of channel gate manufacturers and users to facilitate the maintenance, debugging, and installation of the tripod turnstile in the future.
