Swing barrier install in Xianyan airport
swing-barrier-install-in-xianyan-airport
Tongdazhi swing barrier TDZ-B358 is very popular in the market .It has install in Xianyan aiport .
The model detail:
Model No: TDZ-B358
Size:1400x185x1000mm
Swing barrier in Xianyan airport
Basic Function
² The entry and exit directional can be set independently, free mode / forbidden model
² Automatic reset function: The swing barrier will open the arm after receiving the valid opening signal when standby. The swing barrier will return to the hindered zero position automatically under the following situation：
--. Within the allowed time, pedestrians have been detected to pass through the passageway in specified direction;
--. Over the allowed time, there is no people passing through the passageway.
² Self-recovery function: The swing barrier do not return to the hindered zero position because of human intervention. After revoking human intervention, the gate automatically return to the hindered zero position.
² Direction indicator: The direction indicator is installed on the top of the housing cabinet to indicate the valid passing direction
² Compatibility: Equipped with dry contact signal input interface can make sure compatible with all kinds of access controllers
Equipment installation
u Ready tool to install equipment, need the impact drill, wrenches, hammers, expansion screws M10 * 15 or M12 * 15 of 4 pieces each machine.
u Multi-channel devices installed, please be sure to follow the numbering sequence on the machine display,the chassis number on the cover on the same side, are not free to replace the machine direction, in accordance with the number placed in the machine,ready to begin installation；
u After placing machine, then powered on，confirm alignment of flap turnstile and arm,every edge of the chassis is in the line.After make sure spacing on both sides of the chassis is same,mark hole positioning and burying position. Please be noted the space between swing arm is 50-100mm;
u After confirming the fixed line holes and hole locations,drilled holes,and embedded M10 or M12 expansion screws;
u The strong and weak electric cables respectively cable with 3/4 "PVC pipe, buried with cement to the appropriate location;
u Each enclosure move to corresponding mounting position,level Bolt-bit one by one;
u Check whether the system composition and working methods are correct or not，After check it is correct,then start the next step work;
u Refer to wiring diagram,connect the power cord,control line and system protective ground line;
u After check the state examination and functional debugging,then tighten the foot nut.
Contact information:
