tripod turnstile installation instructions
tripod turnstile installation instructions
Installation methods and procedures. First of all, how to install the tripod turnstile access control reasonably should pay attention to the following questions
question:
= The tripod turnstile access control should have a complete communication with the customer before starting the installation to understand the on-site situation
The environmental situation is to determine the plan:
1. Formulate a construction plan
Whether the installation site is used in the open air or indoors, choose to wear protective clothing in the open air.
Water box tripod turnstile to avoid the corrosion of the circuit board caused by weather; the choice of waterproof box should also be
More environmental characteristics, the South can use the plastic waterproof box and the heat dissipation system, the North can use
Add temperature control system with iron waterproof box.
Select the wiring method according to the distance between the main control computer and the tripod turnstile access control (is to go
The communication method between the open line or the dark line and the controller (generally the distance between the computer and the tripod turnstile access control)
Within 800 meters, we recommend choosing 485 communication, and if the distance is more than 800 meters, we choose
TCP network communication.
2. Preparations before installation
Generally, before installation, according to the actual size of the tripod turnstile, 2 grooves should be pre-buried on site.
For the plastic pipe with points to 8 points, there is a gap of 50-00mm between the tripod turnstile and the tripod turnstile, which is for the back
It is convenient to open the top cover, adjust the machine, and facilitate maintenance, etc. The equipment is embedded between the equipment and must be
Use one rubber tube to run the power line (strong electricity, and another rubber tube to run the signal line (weak electricity, cannot be used at the same time)
When the power line and signal line go through a hose, it is easy to cause safety hazards and communication effects.
will be affected. The embedded pipe should be exposed to the ground 30-40mm high, and the bridge-type tripod turnstile should be
Both sides are better, and the vertical tripod turnstile should be better at the bottom of the middle of the machine.
Three, fixed adjustment
The fixed bottom is fixed with 4-M000 expansion screws, which cannot be swayed, and the appearance of the whole machine is complete
The body is consistent, (before fixing, it is best to use a thin wire to draw a straight line, the vertical and horizontal directions are consistent, the tripod turnstile and the tripod turnstile are
Connect them in series and adjust them one by one until they can be used normally. The tripod turnstile should be in line with the ground
Place it horizontally, so that the effect and the life of the tripod turnstile will be in the best condition.
Fourth, the importance of installing the ground wire
According to what our company has learned in the past, some customers have installed the tripod turnstile after
There are no valid connections. The shell of the tripod turnstile is mostly stainless steel, if the shell is not grounded
The line will cause a great safety hazard to the user's personal safety.
