Turnstile gate installation and precautions
turnstile gate installation and precautions
Various selection methods of turnstile gates, various types of differences, etc. We have spent a lot ago. Today, this article is mainly from the perspective of installation and the installation of channel gains and precautions when using it. Installation is used to extend the service life of the equipment, better for us.
The length of the life of the turnstile gate has a certain relationship with the original installation, so we should do it in a reasonable compliance method when installing, and should pay attention to the following aspects. :
1, the installation of the smart turnstile gate, is generally on the horizontal floor or the gates base. Life.
2, the installation of the shutter is recommended to use 6 points of galvanized tube when the pre-buried tube is preferably connected to the power line to select a regular national standard cable, buried underground, can maintain a long time period. It is also good for usage time for the entire gate.
Picture of Gate Machine - High-end Wing 38838 Speed Gate
3, the gate needs to prevent slip-proof processing on the ground during installation, prevent people from slippery because of the sliding, and must be placed on the gate to prevent seepage.
4, the gate adjustment is marked after the installation position is marked, and the drilling depth is more suitable at 10-13cm when drilling, and it is recommended to prepare the Defensive Bolt of M12 when it is fixed. Fixed screws.
5, the gate is installed and careful testing after the picking line, if the detection is not normal, you need to re-install the shutter device.
6. After the shutdow is installed and commissioned, the boot operation test is performed. After passing the test test of the field technician, it can be put into use after passing the test.
The above is the precautions for the installation of several gates we have summarized. In addition to installation, care should be careful, and the maintenance of the gate is also very important.
High-end rectangular sputum after installation photo 98878 speed Gate
1. Channel brake is a highly reliable device, even in a high flow environment is fully competent. The workload that needs to be maintained is extremely small.
2. The turnstile gate requires regular cleaning, especially important to keep the beam window cleaning. Marble and glass doors typically need to use a corrosive cleaners every week, clean with a soft non-lost rag. Stainless steel surface, it is recommended to use WD-40 dehumidify anti-rust cleaner to wipe it.
3. It is recommended to check, clean, lubricate each year. Check if the mechanical part is loose and fastened. An overhaul needs to be repaired once a year, and the part of the wear is replaced. The power must be turned off before opening the cover (please keep the ground connection)
4. Use compressed air to clean the dust on the electronic component, use a vacuum cleaner to clean the bottom.
5. The infrared acrylic mirror also uses a non-corrosive cleaning solution, which is cleaned with a soft non-lost rag.
6 Prior to replacing the cover, further view the situation in the chassis, such as whether the electrical component wiring is intact, check the maintenance tool, clean the debris.
The above is the steps for the steps of gate maintenance, so every link is completed in accordance with standards and requirements, ensuring that the turnstile gate will avoid the equipment that the equipment cannot be used due to small problems during subsequent use, resulting in after-sales issues.
